The Ford Barn - View Single Post

aandkt · 08-26-2015, 06:44 PM

I have a 9" Ford Bronco Rear in my 1936 Ford convertible.
The Pinion angle is no problem.
Does anyone have any good ideas how to set the rear evenly on the springs?
I have to position the spring perches (which are new and not welded to the rear housing) evenly apart and evenly from the backing plates
and weld them in place.
Thanks
ART

08-26-2015, 06:44 PM	#1
aandkt Senior Member Join Date: May 2010 Location: LI NY Posts: 222	Nine Inch Ford rear end in 1936 Ford I have a 9" Ford Bronco Rear in my 1936 Ford convertible. The Pinion angle is no problem. Does anyone have any good ideas how to set the rear evenly on the springs? I have to position the spring perches (which are new and not welded to the rear housing) evenly apart and evenly from the backing plates and weld them in place. Thanks ART