Thread: discussion on way to make a press for stainless to hubcap dish
View Single Post
Old 12-11-2019, 09:25 AM   #10
nelsb01
Senior Member
 
nelsb01's Avatar
 
Join Date: May 2010
Location: Up North
Posts: 626
Default Re: discussion on way to make a press for stainless to hubcap dish
Hope these pictures explain my hubcap re-install.
All I have left to do is place some chauk in the hole that was originally drilled in the steel to pop off the stainless.
Attached Images
File Type: jpg IMG_5081.jpg (30.5 KB, 46 views)
File Type: jpg IMG_5082.jpg (55.0 KB, 46 views)
File Type: jpg IMG_5083.jpg (57.4 KB, 46 views)
File Type: jpg IMG_5084.jpg (51.0 KB, 42 views)
File Type: jpg IMG_5085.jpg (51.5 KB, 42 views)
File Type: jpg IMG_5086.jpg (51.4 KB, 40 views)
File Type: jpg IMG_5087.jpg (58.8 KB, 41 views)
nelsb01 is offline   Reply With Quote