The Ford Barn - View Single Post - For those with machining experience. Sleeve fitting??

flatheadmurre · 11-19-2019, 06:02 PM

I have melling sleeves on the shelf if you need.
How much interference fit you want depends on if you´re going to use a sealer or not...
Old style is bore leave a notch in the bottom for the sleeve to stand on...pound it down with the BFH or press..cut it flush.

11-19-2019, 06:02 PM	#4
flatheadmurre Senior Member Join Date: Apr 2015 Location: Sweden Posts: 3,045	Re: For those with machining experience. Sleeve fitting?? I have melling sleeves on the shelf if you need. How much interference fit you want depends on if you´re going to use a sealer or not... Old style is bore leave a notch in the bottom for the sleeve to stand on...pound it down with the BFH or press..cut it flush.