The Ford Barn - View Single Post

larrys40 · 12-04-2018, 10:01 PM

Brent
I initially responded but I did so too quickly and reread your plea for a tool.
so I'm editing my response. I'm not sure if it is the same diameter for what you are looking for but the KRW 6050 carb tool for V8 I believe may fit. I use mine when needed for main jet change and removal. there was several on ebay that just sold very reasonably. I almost bought the last one to have as a spare... but let it go... maybe someone needs one other than to sit on the shelf as I have a good one.

I tried one on a float valve I have and it fit... That's where KR wilson tools come in handy. Yes one can be made but of course that takes time. I like the fact of the large plug remover feature on it as well. check out the link below. What kind of carb are you working on for it?

https://www.ebay.com/itm/L1435-KR-Wi...%3AMEBIDX%3AIT

All the best !
Larry shepard

12-04-2018, 10:01 PM	#5
larrys40 Senior Member Join Date: May 2010 Location: St Charles , Missouri Posts: 1,998	Re: Carburetor Float Valve Seat Wrench Brent I initially responded but I did so too quickly and reread your plea for a tool. so I'm editing my response. I'm not sure if it is the same diameter for what you are looking for but the KRW 6050 carb tool for V8 I believe may fit. I use mine when needed for main jet change and removal. there was several on ebay that just sold very reasonably. I almost bought the last one to have as a spare... but let it go... maybe someone needs one other than to sit on the shelf as I have a good one. I tried one on a float valve I have and it fit... That's where KR wilson tools come in handy. Yes one can be made but of course that takes time. I like the fact of the large plug remover feature on it as well. check out the link below. What kind of carb are you working on for it? https://www.ebay.com/itm/L1435-KR-Wi...%3AMEBIDX%3AIT All the best ! Larry shepard Last edited by larrys40; 12-05-2018 at 12:16 AM.