View Single Post
Old 10-02-2019, 10:27 AM   #12
Ol' Ron
Senior Member
 
Ol' Ron's Avatar
 
Join Date: May 2010
Location: Chester Vt
Posts: 7,082
Default Re: Bearing dimentions

Before I had a Bearing mic, I too, used the wrist pin method. But I never thought that was very accurate . This morning I used a magnifier hat and a light to read the mic, and that works very well, Your not going to believe this, but I have several hundred used bearings. So getting the right clearance was easy. Unfortunately, that was many years ago.
Ol' Ron is offline   Reply With Quote