View Single Post
Old 01-31-2016, 11:05 AM   #153
Curt in AZ
Senior Member
 
Curt in AZ's Avatar
 
Join Date: Sep 2015
Location: Clarkdale, AZ
Posts: 119
Default Re: 1941 Ford Pickup frame-off restore for the next generation

Quote:
Originally Posted by mrfliboy View Post
Got the Booth almost completed, (done) hoping to lay some paint down this weekend. Kinda hard to show the size, basically 12' x 8'.

Picked up my 2K Epoxy, gun, sandpaper and ready to paint.

Did some rust treating with KBS RustBlast, like it much better than Ospho. Seemed to work a lot faster.

Underside of running board was wire brushed, degreased, Rustblast treated, scrubbed during this time with scotchbrite pad for 1 hour. Rustblast wiped off, than rinsed with water. Compressed air dried. 2K epoxy sealer applied with gravity feed gun.

High build primer applied 3 coats

Got my work cut out for me for the next few winter months. LOL
Wow, what an amazing illustrated chronology of the build. How are you moving air through the booth? Thanks.
Curt in AZ is offline   Reply With Quote