The Ford Barn - View Single Post - Do ALL banjo rearends require a hub puller to remove the brake drum?

rotorwrench · 06-24-2018, 05:31 PM

The ones where it wasn't torqued properly might just fall off unless it sheared the key. With the torque they had on them and time installed unknown, it's kind of a crap shoot as to whether it will come of easy or not. I'd always figure they would be tight going into a job like that. If it hasn't been on long then it might come off easier. With a tapered shaft you just never know. I'd sure want it tight.

06-24-2018, 05:31 PM	#4
rotorwrench Senior Member Join Date: Jun 2010 Location: San Antonio, Texas Posts: 16,436	Re: Do ALL banjo rearends require a hub puller to remove the brake drum? The ones where it wasn't torqued properly might just fall off unless it sheared the key. With the torque they had on them and time installed unknown, it's kind of a crap shoot as to whether it will come of easy or not. I'd always figure they would be tight going into a job like that. If it hasn't been on long then it might come off easier. With a tapered shaft you just never know. I'd sure want it tight.