Sponsored Links (Register now to hide all advertisements)
Quote:
Originally Posted by Phil Gillespie
Thanks for that info.
Will check measurements. But with items apart seem a little too easy to fit on
Will maybe go for the loctite. Is this the same which can be used for the clutch plate securing screws? Or to just use new ones with spring washers?
Appreciated
Phil NZ
|
New split type lock washers are all that are needed for the clutch plate.
Locktite is okay in many applications but was never intended to fill voids.
Of course it's up to you which direction you'll take but me? - given the labor involved to replace that hub later, now may be the time to skip the easy route and do it properly.