The Ford Barn - View Single Post

Terry,OH · 07-10-2019, 05:48 AM

Indian head should be good and it should not change any of your spec. don't over do it. 0.032 thick gaskets is a LOT usually around .008 on one side and about the same on the other. You don't split the gaskets evenly. The gaskets on the left control the ring and pinion mesh and the gaskets on the right control the carrier bearing. Make sure both of the carrier bearing races are installed all the way.

07-10-2019, 05:48 AM	#8
Terry,OH Senior Member Join Date: May 2010 Posts: 4,751	Re: More banjo questions for the gurus Indian head should be good and it should not change any of your spec. don't over do it. 0.032 thick gaskets is a LOT usually around .008 on one side and about the same on the other. You don't split the gaskets evenly. The gaskets on the left control the ring and pinion mesh and the gaskets on the right control the carrier bearing. Make sure both of the carrier bearing races are installed all the way.