Re: Splash apron hole size
Do you have the "donut gasket" (anti-rattle) where the arm comes through the splash shield?
A good plan would be to make the hole large enough to pass the gasket through and allow the gasket to seat on its groove.
You want a little compression in fit - maybe such that the tapered arm can be passed through the hole but everything is "snug."
Plumbers taper reamers (used for de-burring pipe) work good for this. Be sure to do both sides and follow up with fine sandpaper lest you make a sharp edge which cuts the seal rubber.
Joe K
__________________
Shudda kept the horse.
|