Quote:
Originally Posted by SteveB31
Seems to me the easy way to make one is buy a complete original tie rod with ends on it. Buy one die for one end. Cut the tie rod off on one end, thread it, install the end that was on it. Should I make some? I have many good used tie rods. If these would sell, I will make them. Your thoughts?
Steve @ Bert's
|
As for how they would sell, I made 2, 1 of which I installed when I fitted my reconditioned front end along with the short pitman arm, I had the second one for sale here and it was a little over a year before it sold.
I prefer the using a drag link with a adjuster sleeve over using tie rod ends as there can be a clearance problem with the axle, due to the clamp bolt.