View Single Post
Old 08-29-2014, 01:12 AM   #1
JohninKuranda
Senior Member
 
JohninKuranda's Avatar
 
Join Date: Jan 2014
Location: Kuranda, Queensland Australia
Posts: 126
Default Rear Axle Housing woes

Some time ago I posted about a leaking rear axle. When taking it apart, I realised that the Rear Axle Housing Cap and felt washer was wafer thin and needed replacing. Parts finally arrived. Question- is there a trick (apart from a piece of timber and a heavy hammer) to properly seat the Cap to the required depth to allow the brake drum and wheel hub to seat properly? Second question - and a tad embarrassing - when disassembling I forgot to note the positioning of the key. Where does the tapered section go? Seems that there are four possibilities.

Appreciate any advise that can be provided.

Cheers
John

Last edited by JohninKuranda; 08-29-2014 at 02:48 AM.
JohninKuranda is offline   Reply With Quote