The Ford Barn - View Single Post - 59A Flywheel Machining & Clutch refitting..

Phil Gillespie · 01-19-2020, 11:06 PM

Its now all sorted. A washer took out the 2mm as without the washer shouder on bolt bottomed out giving the 2mm gap. All good and engine run up on test stand.
Next project to swap engine out of 46 Merc Coupe and put this one in.
Phil NZ

01-19-2020, 11:06 PM	#11
Phil Gillespie Senior Member Join Date: Sep 2011 Location: Christchurch New Zealand Posts: 1,610	Re: 59A Flywheel Machining & Clutch refitting.. Its now all sorted. A washer took out the 2mm as without the washer shouder on bolt bottomed out giving the 2mm gap. All good and engine run up on test stand. Next project to swap engine out of 46 Merc Coupe and put this one in. Phil NZ