View Single Post
Old 01-19-2020, 02:42 PM   #9
Mart
Senior Member
 
Mart's Avatar
 
Join Date: May 2010
Location: Solihull, England.
Posts: 6,263
Default Re: 59A Flywheel Machining & Clutch refitting..

Phil, take everything off and test fit a bolt into a hole. It should end up with less clearance than the combined thickness of the pressure plate and a lock washer.

The bolts may be correct but your flywheel might have been skimmed enough to make either the depth of the holes or the depth of the counterbore not deep enough.

Mart.
Mart is offline   Reply With Quote