View Single Post
Old 01-19-2020, 02:32 PM   #8
Phil Gillespie
Senior Member
 
Phil Gillespie's Avatar
 
Join Date: Sep 2011
Location: Christchurch New Zealand
Posts: 1,138
Default Re: 59A Flywheel Machining & Clutch refitting..

Quote:
Originally Posted by Bored&Stroked View Post
And Yes - the clutch should be firmly against the flywheel surface!!!!!
I got new shoulder bolts from Michael Driskoll 3rd Generation.
But fitted without washers. So could be shoulder coming up against the flywheel. Will recheck and get it as it should be.
Important info being cover should make contact on flywheel.
Many thanks as always for good info.
Phil NZ
Phil Gillespie is offline   Reply With Quote