View Single Post
Old 10-29-2019, 08:33 PM   #1
Colonel Biggs
Senior Member
 
Join Date: Jun 2010
Location: Houston,, Texas
Posts: 132
Default Non Model "A" Electrical Question

I need to test the capacitors in my HP printer/scanner. Because there are about ten of same, I would prefer not de-solder each one and then test. However, to test them in circuit, I believe that I need an ESR meter. Fluke, for example, sells them, but their meter prices are in the hundreds of dollars. I am hoping that there is someone on the board who is also relatively expert in electronics. There must be a cheaper meter that will enable me to get the job done.

This is obviously a break from my Model "A" duties. But, I'm hoping that there is a restorer out there who has been through this drill.
Colonel Biggs is offline   Reply With Quote