View Single Post
Old 02-25-2018, 09:13 AM   #4
glennpm
Senior Member
 
glennpm's Avatar
 
Join Date: Sep 2014
Location: Wiscasset, Maine
Posts: 775
Default Re: 1935 Columbia clutch pedal picture

Hi Dave,

From what I could find, the bracket slips over the clutch release arm and not over the clutch pedal arm. I have a 40 Columbia in my 32 and the 40 does slip over the clutch pedal arm.

From the 35-36 instructions:

OPERATION No. 8 (USE SUB-ASSEMBLY No. 5 )
Install clutch pedal valve on bell housing See illustration No. 8. Remove center cap screw on left side of bell housing
and attach valve at this point using longer cap screw provided with valve.
IMPORTANT: Dowel on bracket of valve must fit dowel hole in bell housing which locates valve in correct position.
Disconnect clutch pedal spring from clevis pin.

Remove clutch pedal clevis pin.

Assemble pressed steel lever extension over clutch pedal as shown in illustration No. 8 and letter "J" on General Diagram. This lever extension must be a snug fit over clutch shaft so that there is no lost motion.
Insert new clevis pin furnished.
Replace clutch pedal spring.
Assemble pedal valve link, as shown in illustration No. 8.
Attached Images
File Type: jpg 35-36 clutch & Brake assembly.jpg (80.9 KB, 27 views)
File Type: jpg DSCN3509 brkt comment.jpg (89.7 KB, 28 views)
File Type: jpg Illustration No 8.jpg (19.6 KB, 33 views)
glennpm is offline   Reply With Quote