Quote:
Originally Posted by Tom Wesenberg
The housings aren't all the same. Try it for fit to the driveshaft with no gasket, and see if it rocks a little. Some guys have stacked gaskets to lift the housing, if it's too tight to the driveshaft gear.
|
Tom; thank you. I did check the fit, without the gasket, and used a 3/16" square key ( key stock), and there was a bit of slop in the gear. When I put it together, I used 2 gaskets. I filled the housing with 600 W gear oil. The housing was still full of oil, when I took it down.
The speedometer cable has both support clamps in place (chassis over muffler, and firewall).
I am perplexed.
Thank You;