The Ford Barn - View Single Post - Copper Clad Head Gasket on a Brumfield 5.9 Head

HS · 06-04-2019, 06:26 AM

Brent,
What? did you say, Im cornfused? "most people suggest that the seam (-which likely/often imprints the adjoin metal when torqued) is placed towards the cylinder head as that is easier to resurface than the block's deck surface"

So that would Be placing the Gasket "Up" on the block Is that correct?

Thanks,
Hugh

.

06-04-2019, 06:26 AM	#5
HS Senior Member Join Date: Aug 2014 Posts: 127	Re: Copper Clad Head Gasket on a Brumfield 5.9 Head Brent, What? did you say, Im cornfused? "most people suggest that the seam (-which likely/often imprints the adjoin metal when torqued) is placed towards the cylinder head as that is easier to resurface than the block's deck surface" So that would Be placing the Gasket "Up" on the block Is that correct? Thanks, Hugh .