View Single Post
Old 11-18-2019, 09:34 AM   #29
Mart
Senior Member
 
Mart's Avatar
 
Join Date: May 2010
Location: Solihull, England.
Posts: 8,733
Default Re: Flathead Friday. New project. Rusty Crusty Flatty. VIDEO.

I can report the teardown is going well so far.
Valves. Out.
Crank. Out.
Rods and pistons. Out.
Lifters. Out
Cam. Out.

I was just saying to my son, the secret is applying just enough brute force to get it done.

I will be sharing the videos once edited up. I do have some good footage.

Studs next. that can get messy.

Mart.

PS the angle iron piece has no gussets. It's about 2-1/4 (probably 60mm) angle with a 1/4 or 6mm thickness. It's not going to flex, the blocks ain't that heavy.
Mart is offline   Reply With Quote