Sponsored Links (Register now to hide all advertisements)
That is a shame - Barney would NOT like to hear about this. I bought a few sets of his heads from him, along with blower manifolds, etc (back in the early 2000's). Barney always did extremely high quality work. The only chambers I've seen on his heads were cast - and at the right depth to run a .425 lift cam with .050 head gaskets. I always loved the work that Barney did - guess I'm fortunate to have "original stuff" . . . and I'll stay away from the "new" ones that H&H is making. The dumb part is if they had the correct CNC programs, machine fixturing/setup and operators - they should be dead-nuts correct (that is what CNC does). But any machine/program process - is only as good as the setup and operator. Sure seems to be lacking in both departments!
Here are the chambers on the heads I have on my 284 cube motor in the 32 Cab:
2015-07-17 18.15.37 copy.jpg