[Kube]

Originally Posted by tubman

I don't think the precise measurement is as important as having them all the same.

Here is an excercise that I went through : https://www.fordbarn.com/forum/showt...ghlight=clutch

I learned the hard way about this. After two remanufactured plates from NAPA were installed (yep TWO), I took the plate in to my shop and measured the fingers. None were within specification and as such I could never get the pedal adjustment even close to acceptable.
There IS a specification for this but it requires the plate to be bolted down. Instead of bolting it upon a disc, I used blocks at the specified thickness.
I'll try to find the spec if so desired.
Now? I buy only NEW from Ft. Wayne.

If the plate is brand new - not a remanufactured plate, you will probably be okay. probably.