View Single Post
Old 06-02-2019, 10:05 AM   #123
GOSFAST
Senior Member
 
GOSFAST's Avatar
 
Join Date: May 2010
Location: Long Island, NY
Posts: 937
Default Re: First Flathead Build

Here's a couple shots of the lifter pinning holes!

Thanks, Gary in N.Y.

P.S. Mentioned above, drill them as low as possible without breaking through on the edge of the casting. We drill them with a 12" 3/16" bit, all by hand.
Attached Images
File Type: jpg Flathead Ford Lifter Adj Holes A.JPG (73.9 KB, 121 views)
File Type: jpg Flathead Ford Lifter Adj Holes B.JPG (84.2 KB, 115 views)
File Type: jpg Flathead Ford Lifter Drilling Bits.JPG (84.9 KB, 112 views)
GOSFAST is offline   Reply With Quote