08-12-2016, 11:48 AM
|
#13
|
Senior Member
Join Date: May 2010
Location: NC
Posts: 2,975
|
Re: new engine using oil
Quote:
Originally Posted by Jim Brierley
I would run conventional, modern oil. I use 20-50. I recommend doing the following to seat the rings, oil on the side of the engine indicates a ring problem. Now would be a good time to re-torque the head nuts. Procedure: 1- Warm the engine by driving it gently for a few miles. 2- in high gear, accelerate using full throttle from 20 mph to 40 mph. 3- slow back down to 20 slowly (don't back off the throttle completely) 4- do this 10 times in reasonably quick succession. This should completely seat the rings and solve the problem. Good luck!
|
plus 1
|
|
|