Quote:
Originally Posted by GOSFAST
One item to look into is the space between the piston pin bosses and the rod pin ends, hard to tell from your "photos" but it does appear a bit "tight" in there!
This issue we find on many of the Pontiacs we build using the stock (OEM) connecting rods and most aftermarket pistons!
Thanks, Gary in N.Y.
P.S. On the Flathead platform we like to see about .060" per side, that would be equal to 1/8" overall. Any lesser amount (per side) and I would recommend "narrowing" the rod eyes some as needed. Correcting this (if necessary) will have NO effect on the overall state of the balance!
|
Hey Gary thanks for the input, the clearance is about .060" per side, the pic is deceiving