View Single Post
Old 12-07-2012, 07:44 PM   #1
JtownJoe
Senior Member
 
JtownJoe's Avatar
 
Join Date: May 2010
Location: Johnstown, PA
Posts: 334
Default accelerator linkage

Is it possible to remove accelerator linkage assembly while engine is in the vehicle (30 Tudor). I have the head off & can't seem to find a way to remove assembly, no matter which way I try to take it out it hangs up on the firewall or the block/flywheel housing. Mine has developed slippage in it & I've lost some of the full travel on the carb side as compared to the pedal side.
JtownJoe is offline   Reply With Quote