The Ford Barn - View Single Post

katy · 02-02-2019, 12:54 PM

Sponsored Links (Register now to hide all advertisements)

You could possibly elongate the holes for the lower contact point mounting and then move the point up enough to give the desired air gap at the core.

02-02-2019, 12:54 PM	#6
katy Senior Member Join Date: Jun 2015 Location: Red Deer, Alberta Posts: 5,042	Re: Bench testing a generator cutout Sponsored Links (Register now to hide all advertisements) You could possibly elongate the holes for the lower contact point mounting and then move the point up enough to give the desired air gap at the core. __________________ If you don't hear a rumor by 10 AM, start one!. Got my education out behind the barn!