Quote:
Originally Posted by Capt Kirk
Regarding seals, I was planning on replacing the axle and hub seals...didn't give much thought to the seal in the torque tube. I wasn't planning on pulling the torque tube off...is this seal you're talking about at the trans end of the torque tube?
|
Kirk....Here's a drawing showing the B-4245 seal at the FRONT of the torque tube. Remember, you need to remove that little snap ring to pull the TT off the drive shaft, and to remove the speedo gear, roller bearing, etc. from the front of the shaft. Ya done good getting that rear totally un-glued today. DD