View Single Post
Old 11-30-2019, 02:15 PM   #16
Ronnieroadster
Senior Member
 
Ronnieroadster's Avatar
 
Join Date: Dec 2010
Location: East Coast in CT
Posts: 1,529
Default Re: Early V8 Dyno Work

Quote:
Originally Posted by frnkeore View Post
I'll have to get JWL's book.

Can I assume that no one else has had their engine on a dyno (what about a chassis dyno), even to jet the carbs?




I have had my engines on the rear wheel dyno a number of times however the results must remain a secret. All I can say is more than one HP per cube at the wheels and over 200 MPH on the race surface. Very valuable for getting a good jetting tune up.
Ronnieroadster
__________________
I use the F word a lot no not that word these words Flathead , Focus and Finish.
"Life Member of the Bonneville 200 MPH Club using a Ford Flathead block"
Owner , Builder, Driver of the First Ford Flathead bodied roadster to run 200 MPH Record July 13, 2018 LTA timing association 200.921 in one and a half miles burning gasoline.
First ever gas burning Ford flathead powered roadster to run 200 MPH at Bonneville Salt Flats setting the record August 7th 2021 at 205.744 MPH
Ronnieroadster is offline   Reply With Quote