The Ford Barn - View Single Post

Mike C · 10-05-2016, 03:13 PM

i read somewhere wher there were 2 different timing covers. One was cast iron which used a cast iron dist. housing and the other was cast aluminum which used an aluminum housing. Is that correct? Also, if my distributor is okay, was ther a rotor retaining clip for the rotor and if so what is the numer, where exactly does it go and where can I get one?
Thanks again

10-05-2016, 03:13 PM	#20
Mike C Junior Member Join Date: Oct 2010 Location: Hayesville, NC Posts: 9	Re: distributor problrrm? i read somewhere wher there were 2 different timing covers. One was cast iron which used a cast iron dist. housing and the other was cast aluminum which used an aluminum housing. Is that correct? Also, if my distributor is okay, was ther a rotor retaining clip for the rotor and if so what is the numer, where exactly does it go and where can I get one? Thanks again