Re: Model A Radio
To answer post 14 ?, our mid '30's 2 pole switch = 1 ignition switch wire to instr. panel light and 1 to ammeter, the center wire to coil. We hooked the (-) input convertor wire to the panel light side and the fused output wire to the radio, the convertor body term. to (+) ground. Also installed a small usb port the same way. "Fancy" technology not available when this was done.
The antenna as posted in #16 is not the best, but the radio has a small tape slot for parade use..
Last edited by duke36; 10-11-2017 at 11:28 AM.
|