View Single Post
Old 10-16-2021, 09:54 AM   #2
1955cj5
Senior Member
 
1955cj5's Avatar
 
Join Date: Apr 2015
Location: Boise, Idaho
Posts: 1,578
Default Re: Routing of Speedometer cable on 29 CCPU

I'll give it a shot....

The first picture shows it routed over the muffler, to a clip on the upper frame rail, then forward under the toe board into the engine compartment.

Inside the engine compartment it just loops back through the firewall.

Once inside the cab there is a d-nut near the firewall hole for another clip, clip is missing in my picture but the nut is there.

Not a good under dash picture but it routes through the hole in the channel under the gas tank to the speedometer.

That extra wire is for the water temp gauge.

My truck was a farm truck....it once had a hot water heater...that is what that patched hole was for...
Attached Images
File Type: jpg P1010835_LI.jpg (52.9 KB, 76 views)
File Type: jpg 2015_0814modelajeep1579.jpg (74.1 KB, 70 views)
File Type: jpg P1050191.jpg (44.8 KB, 22 views)
__________________
Early '29 CCPU that had a 4-speed, but not any more.......in the family since '62

Last edited by 1955cj5; 10-18-2021 at 02:55 PM.
1955cj5 is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)