Re: Diaphragm Clutch
Richard,
If you decide to use the diaphragm clutch, the fingers at the center must be machine shortened, otherwise they will not clear the throw out bearing. You can use the same clutch disc as used with the V8 and A . Also, the flywheel must be drilled and tapped for the diaphragm or V8 pressure plate. Also the diaphragm clutch is much lower profile than the V8.
I am sure you know the above information but thought it would not hurt to list again.
Here in Quincy we are lucky that one of our members has a nice complete shop set up at he residence and does any machine work we may need.
Ron
|