View Single Post
Old 03-25-2020, 08:36 PM   #37
Ronnieroadster
Senior Member
 
Ronnieroadster's Avatar
 
Join Date: Dec 2010
Location: East Coast in CT
Posts: 1,528
Default Re: Timing gear oiling?

Well at least all those worn out gears at the front of the Canadian flatheads will now be a thing of the past. And think about all the other worn out stuff found in the front of the engine the distributor drive gear the distributor gear as well as the distributor shaft bushings finally a solution to that as well. Wonder if a seal will now be needed below the distributor to keep oil from leaking out with all the extra oil flying around. LMAO
However this might help improve fuel economy.
__________________
I use the F word a lot no not that word these words Flathead , Focus and Finish.
"Life Member of the Bonneville 200 MPH Club using a Ford Flathead block"
Owner , Builder, Driver of the First Ford Flathead bodied roadster to run 200 MPH Record July 13, 2018 LTA timing association 200.921 in one and a half miles burning gasoline.
First ever gas burning Ford flathead powered roadster to run 200 MPH at Bonneville Salt Flats setting the record August 7th 2021 at 205.744 MPH
Ronnieroadster is offline   Reply With Quote