Sponsored Links (Register now to hide all advertisements)
Corley:
OK
I put the new module in and connected it up. Fired right up and ran great. I then shut it off and shortened the plug wires. The honda wires were way too long. Tried to start it again and nothing. Seems like the module went out again. Switched back to my "B" distributor and it ran OK. The coil is a Pertronix with about 5 ohms on the primary.
Where did you connect the ground wire from the distributor body? Would the coil mounting bracket be good?
Hope I can get this to run more than 5 minutes per module :>)
Thanks
Dick