Sponsored Links (Register now to hide all advertisements)
Quote:
Originally Posted by glenn in camino
Screw the drain tube back with some JB weld, tighten the valve cover and plastiguage the mains and rods. You should be good to go.
|
JB weld, great idea. Sounds like i have to pull the valve cover to remove the main caps so I am going to check the valve lash while I'm in there. I took it for a short jaunt before pulling the pan and it runs quite a bit better as far as smooth goes but doesn't pull as good as before. About 47 MPH and that's it. Going to recheck the timing after i get this inside stuff done. Might have it a bit retarded.