Re: About to start a flathead V8
Ok, so to even get close to a point where I could think of giving this motor a twirl I have to take care of the distributor which we talked about already. The radiator hoses are shredded and even look to be somewhat charred. So, on that note has anyone used any particular kit that has worked well or are flex hoses pretty much the "go to". I measured it at approximately 25" so they are fairly long.
Next, distributor cap and wire sets...? I would like to know what has worked well for others so I don't waste funds...
Eventually I would like to gravitate towards 12v but if that isn't recommended please also advise...
|