View Single Post
Old 07-11-2018, 09:01 PM   #12
larrys40
Senior Member
 
Join Date: May 2010
Location: St Charles , Missouri
Posts: 1,994
Default Re: Exhaust leak at manifold

I concur with Ron on above post. I saw a young fellow last week who spent a lot of money in a Weber and header setup like that and in all honesty he would have saved a ton of money and ran better for his stock worn out engine than the setup. Unfortunate advice and way to much unnecessary funds spent from the forum here in my opinion.

His appeared to havechecsamd issue. I think it should be surfaced the same but agree the larger face washers would pull in better then he small ones supplied.

My vote would be a stock manifold but you’ll most likely have to find someone willing to surface them to get them to seal properly
Larry shepard
larrys40 is offline   Reply With Quote