[swedishsteel]

I've used the rocker panel patch, lower fender patch, cowl patch and all needed to be reworked to match the original sheet metal: the rocker panel is straight and that part of the body is curved--very difficult to match the quarter panel; the same for the cowl patch being straight while the original body is curved; the lower fender panel had to be sectioned both on the outer part and where it meets the running board. Also, the body line of the cowl patch, quarter panel and lower door panel do not match the original, so unless you use all three on the same car, where the original and patch meet needs to be worked so they blend together. I appreciate that EMS is making these panels, but I don't think it would take a whole lot to go from "sorta fit" to "it fits with no reworking". Rod