[FrankWest]

Originally Posted by rbullockv8

These pics show the finished product for the bottoms. The seat backrest just has the cover pulled tight over the padding, but it's not fully secured yet, so it has a few wrinkles.

I think on the 32 open cab that the back top edge of the cover is supposed to wrap around the wood trim piece that goes around the back of the cab. However, this kit is, I think, made for a closed cab where the seat back is wrapped with the cover and attached differently. I think I can make it work as-is, so I'm not stressing over it.

Overall, I'm just amazed at how well these turned out. Took me about 90 minutes to do the two seat bottoms (not counting the time I drove to Ace Hardware, then Harbor Freight to find more 1/2" staples for my air stapler!).

Beautiful