View Single Post
Old 11-11-2019, 06:55 PM   #4
BRENT in 10-uh-C
Senior Member
 
BRENT in 10-uh-C's Avatar
 
Join Date: May 2010
Location: Eastern Tennessee
Posts: 11,486
Default Re: Making an A axle steer easier

An improperly shimmed spindle bolt bearing will make one very hard to steer. Make sure the load of the spindle is actually being supported on the spindle bolt bearing, -and not the spindle rubbing on the axle beam boss.

Next, I would say the steering on the tractor was/is likely worn however the box should have many turns from lock-to-lock. Disconnect the Pittman arm to see whether the steering gearbox is turning stiffly or whether it is in the steering arms and tie-rod ends. I cannot see what you are using for tie-rod ends, but if they are stock Model-A type, they may be adjusted incorrectly with too much spring tension.
__________________
.

BRENT in 10-uh-C
.
www.model-a-ford.com
...(...Finally Updated!! )

.
BRENT in 10-uh-C is offline   Reply With Quote