View Single Post
Old 05-05-2017, 10:35 AM   #106
Kube
Senior Member
 
Kube's Avatar
 
Join Date: May 2010
Location: Wisconsin, USA
Posts: 5,254
Default Re: '40 Pickup full restoration project

Quote:
Originally Posted by 38bill View Post
Kube, Just wondering was the hood bent or was it just the original manufacturing process that made it fit poorly? Seems that all the 38's and 39's are out of alignment (especially where the hood joins the grill) and there is only so much you can do to correct it.
The hood was perhaps the nicest piece of sheet metal with this truck. However, it did not "match" the cowl - being about 1/2" too wide. My opinion? The hood was poorly assembled (welded).
Without going in to too much detail, there were numerous indications that's exactly what the issue was.
Good enough for production no doubt - not good enough for a restoration.
It took quite an effort to get this right but it had to be done.
__________________
"Imagination is a crutch used by those who lack knowledge and intelligence ."
B
. Franklin
Kube is offline   Reply With Quote