View Single Post
Old 12-18-2016, 02:51 PM   #11
Brace Bailey
Member
 
Brace Bailey's Avatar
 
Join Date: Sep 2016
Location: Excelsior Springs, MO
Posts: 74
Default Re: Looking for a new Pickup Bed

I went down after Russ/40's remark and started looking at the thickness of the bed. I have some scrap metal - about 16 gage - and it is too thin.
So, I need to determine how thick the metal is on this bugger. It might
Be easier welding than I thought.

I may even go with a repair rear channel, instead of buying the more costly
U channel.
Anyone know what thickness Of steel I should buy?

Also, how are are the rivets to set If I go with new stake pockets?
Attached Images
File Type: jpg IMG_2811.jpg (62.6 KB, 195 views)
File Type: jpg IMG_2809.jpg (49.9 KB, 180 views)
File Type: jpg IMG_2810.jpg (35.3 KB, 169 views)
Brace Bailey is offline   Reply With Quote