Sponsored Links (Register now to hide all advertisements)
Any where from 300 to 700 bucks depending on condition
Cut the casting flash with extra fine scotchbrite pads and a die grinder..then get an assortment of rouge and wool pads for the grinder and get to work
Super Winfield aluminum heads are all over with CR,they were sold as 8 to 1,you need to cc this head before using it,compression ratio above 7 to 1 starts effecting how the engine breathes.Make sure you run a waste metal anode to avoid electrolysis.When raising compression you increase the effect of detonation and 'tighten' the engines tolerance for spark deviation,running a mechanical advance distributor is a good idea.
thumbnail (84).jpg