Quote:
Originally Posted by Paul Bennett
I put a 12v 7" sealed beam bulb on a clean workbench with a 12v battery and voltmeter. Connect battery -12v to the ground terminal of the bulb per diagram above and +12v to the hi beam terminal. The lamp lights and +12v comes out of the low beam terminal enuf juice to light another bulb.
|
Just did the same procedure ( without the clean workbench)
This is with a Sylvania H6024 halogen sealed beam, high beam on, ZERO voltage from the low beam terminal.
At this point it sounds like an anomaly with the bulb.