Quote:
Originally Posted by jimvette59
Is the bearing and race setup all 33 , 34 and where does the thrust washer go on a 33,34 setup. Does the 33,34 setup go in a 35 banjo? I will look into Van Pelts catalog. I looked at 33,34 10 spline and 35,48 pinion setups and near as I can figure is the Thrust washer for a 33,34 setup is supposed to be behind the pinion gear and the first bearing. It looks like the gear itself is tight up against the first bearing. I think you need to take it apart and install the thrust washer first. JMHO
|
What you're describing/advising above is not correct based on the '35 - '40 banjo rears I've dismantled and rebuilt, unless I've totally misunderstood what you're saying. I've never rebuilt a '33 - '34 banjo rear, so I won't comment on those.