The Ford Barn - View Single Post - Not getting fire!! Won't start. PLEASE HELP FAST!!

Frank Nemo · 03-23-2011, 10:58 AM

It only takes a minute or two to change the condeser following this proceedure:

1. Have the new condenser laying next to the distributor.
2. From the passenger side, remove the ground screw first.
3. From the driver's side, remove the terminal screw and keep light pressure on the screw while you slip out the old condenser and slip in the new one.
4. Tighten the terminal screw.
5. Tighten the ground screw.

Tom Wesenberg, thanks for great tip in #3. I can not tell you how many times I have dropped the terminal screw and had difficulty getting a new one started. I can not wait to try your procedure. Thanks for another bit of great advice.

03-23-2011, 10:58 AM	#98
Frank Nemo Senior Member Join Date: May 2010 Posts: 159	Re: Not getting fire!! Won't start. PLEASE HELP FAST!! It only takes a minute or two to change the condeser following this proceedure: 1. Have the new condenser laying next to the distributor. 2. From the passenger side, remove the ground screw first. 3. From the driver's side, remove the terminal screw and keep light pressure on the screw while you slip out the old condenser and slip in the new one. 4. Tighten the terminal screw. 5. Tighten the ground screw. Tom Wesenberg, thanks for great tip in #3. I can not tell you how many times I have dropped the terminal screw and had difficulty getting a new one started. I can not wait to try your procedure. Thanks for another bit of great advice.