Shock absorber, mounting
Hello,
I think there is a new problem. I wanted to install my 4 new Stipe dampers tomorrow. The right damper is immobile rusted, the left damper rotates freely without any damping.
When preparing the transmission mechanism from the old rear dampers, I see that the lever arm for the right side is bent about 15 °. The left arm is straight. The lever length is different.
I do not understand that.
For this I must explain that the wrong leaf spring was very wrongly mounted with many errors and therefore about 2 inches slipped to the left.
I say thanks in advance!
__________________
Beste Gruesse aus Deutschland,
Werner
Ford Model A, Roadster, 1928
Citroen 11 CV, 1947
Hercules W 2000, 1976; (with NSU-Wankel Rotary Engine), Canadian version
|