The Ford Barn - View Single Post

37 Coupe · 10-28-2018, 09:29 AM

Am I correct in thinking that the Model A engine was built using copper head gaskets? I never had much luck with copper on a couple V8 Ford engines so I thought I would go with the Best gasket that Brattons sells,Kevlar and graphite. Anyone successfully use this gasket? I am having second thoughts because of a post from an experienced engine rebuilder who uses only copper.Brattons sells a Felpro copper gasket but only says it has a gray material in the middle not what kind.A better copper gasket available preferably USA?

10-28-2018, 09:29 AM	#1
37 Coupe Senior Member Join Date: May 2010 Posts: 1,835	Copper head gasket or best Kevlar? Am I correct in thinking that the Model A engine was built using copper head gaskets? I never had much luck with copper on a couple V8 Ford engines so I thought I would go with the Best gasket that Brattons sells,Kevlar and graphite. Anyone successfully use this gasket? I am having second thoughts because of a post from an experienced engine rebuilder who uses only copper.Brattons sells a Felpro copper gasket but only says it has a gray material in the middle not what kind.A better copper gasket available preferably USA? __________________ "Never complain,never explain"... Henry Ford II