Quote:
Originally Posted by dp1743
I'm replacing the transmission cover on my 40 Ford Standard and would like to know what the correct fasteners are. I'm sure the original fasteners have been replaced. I don't think the correct setup is with the existing hexhead bolts and nuts. Does anyone know if I should be using panhead or stovehead type bolts. Also, should I use caged nut clips on the floor panel with the bolts, or, are regular nuts proper? How about any washers? Thank you all in advance for any input. Dick in MA.
|
Roy Nacewicz sells a very nice kit for this. There are a number of various screws and cup washers and flat washers used to install the pan. You might save yourself a lot of trouble by simply acquiring the kit. Not very costly...
If you feel you want to dig through your nuts and bolts drawer, let me know and I will post a photo of what you need.